Haier has been appreciated and liked by masses for its innovative technology and eye pleasing utility designs of home Appliances .

READ MORE


Latest Blog



How to keep Your Washing Machine Clean

  • May 20,2018
  • |
  •  0  comments
  • |
  •  Share
    facebooktwittergoogle_pluspinterestlinkedin

Haier has a variety of washing machines whether it is fully automatic or semi-automatic. Washing Machines are essential part of our lives and we need to keep it clean for its long run and uninterrupted services. The method through which we can keep our washing machine clean are as follows:-

1. We need to clean the lint filters after every use as some impurities are stuck in it which resists it from providing a good wash afterwards, cleaning it is important.

  •    Put hand at the indicated position. Push down to take off the lint filter.

 

  •    Put the lint in water and clean it while it is wet.

 

 

  •    After cleaning, insert the bottom of the lint filter (marked with “down side”) into the overflow filter, then push the upper part of the filter in (marked with “upside “).

 

 

The lint filter must be in cleaned in every two months for the better usage of the machine.

 

2. As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to take it off.

 

 

3. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter.

 

 

4. Clean the lint around the filter and flush with tap water.

5. Steps to install the overflow filter.

  •    Install the corrugation pipe.
  •    Insert the mounting plate at the bottom of the filter into the valve cover.
  •    Hang up the hook at the left upper side.
  •    Push the upper part in as indicated in picture

 

 

6. Regular cleaning of safeguard is necessary and not only the upper side but also the lower side should be cleaned. Steps to clean the safeguard cover are as follows:-

 

  •    Take off the safeguard cover. Use the thumb to fasten the indicated groove then take it out as the direction of the figure.

 

 

  •     Clean the underside of the cover
  •     Use the nipper or other spindly clamps to take out the lint, sundries etc.
  •     Install the safeguard cover

 

After finish cleaning, fasten the safeguard cover to the tub bottom, infirm the claw install correctly and hard to fall off.

Use the water to clean the tub wall of the wash tub and the spin tub, and use the brush to scrub.

>>Go Back

Leave a Reply

Your email address will not be published. Required fields are marked *